收藏本站
SX1231
WIRELESS & SENSING PRODUCTS
DATASHEET
4.3. Listen Mode
The circuit can be set to Listen mode, by setting ListenOn in RegOpMode to 1 while in Standby mode . In this mode,
SX1231 spends most of the time in Idle mode, during which only the RC oscillator runs. Periodically the receiver is woken
up and listens for an RF signal. If a wanted signal is detected, the receiver is kept on and the data is demodulated.
Otherwise, if a wanted signal hasn't been detected after a pre-defined period of time, the receiver is disabled until the next
time period.
This periodical Rx wake-up requirement is very common in low power applications. On SX1231 it is handled locally by the
Listen mode block without using uC resources or energy.
The simplified timing diagram of this procedure is illustrated in Figure 21.
t ListenIdle
Rx
t ListenRx
Idle
Rx
t ListenRx
time
Figure 21. Listen Mode Sequence (no wanted signal is received)
4.3.1. Timings
The duration of the Idle phase is given by t ListenIdle . The time during which the receiver is on and waits for a signal is given
by t ListenRx . t ListenRx includes the wake-up time of the receiver, described in section 4.2.3. This duration can be
programmed in the configuration registers via the serial interface.
Both time periods t ListenRx and t ListenIdle (denoted t ListenX in the following text) are fixed by two parameters from the
configuration register and are calculated as follows:
t ListenX = ListenCoef X ? Listen Re solX
where ListenResolX is the Rx or Idle resolution and is independently programmable on three values (64us, 4.1ms or
262ms), whereas ListenCoefX is an integer between 1 and 255. All parameters are located in RegListen registers.
The timing ranges are tabulated in Table 16 below.
Table 16 Range of Durations in Listen Mode
Rev. 7 - June 2013
ListenResolX
01
10
11
Min duration
( ListenCoef = 1 )
64 us
4.1 ms
0.26 s
Page 41
Max duration
( ListenCoef = 255 )
16 ms
1.04 s
67 s
www.semtech.com
发布紧急采购，3分钟左右您将得到回复。

采购需求

(若只采购一条型号，填写一行即可)

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

发布成功！您可以继续发布采购。也可以进入我的后台，查看报价

*型号 *数量 厂商 批号 封装
添加更多采购

我的联系方式

*
*
*
相关PDF资料
SX1240SKA433 TVS
SX1701BI085TRT IC AMP 2.5GHZ 5.3V 16-MLPQ
TA002-10002 LED HEATSINK W/FAN 12V 40X10MM
TC620HEPA IC TEMP SNSR 5V DUAL TRIP 8-DIP
TC623CVOA713 IC TEMP SNSR 3V DUAL TRIP 8-SOIC
TC624VOA IC TEMP SNSR PROG 2.7V 8SOIC
TC6501P125VCTTRG IC TEMP SWTCH OPEN DRAIN SOT23A5
TCS3104FN IC COLOR SENSOR LIGHT-VOLT 4-DFN
相关代理商/技术参数
SX1231H 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Power Integrated UHF Transceiver with On-Chip 20dBm PA
SX1231HIMLTRT 制造商:SEMTECH 功能描述:290MHz- 1GHz RF Transceiver
SX1231IMLTRT 制造商:Semtech Corporation 功能描述: 制造商:Semtech Corporation 功能描述:RF Transceiver FSK/GFSK/GMSK/MSK/OOK 3.3V 24-Pin QFN EP T/R 制造商:Semtech Corporation 功能描述:IC 433/868/915MHZ TXRX 24-QFN 制造商:Semtech Corporation 功能描述:SX Series 290 to 1020 MHz 300 Kbps Low Power Integrated UHF Transceiver - QFN-24 制造商:Semtech Corporation 功能描述:GPSS WL SKU APP1, Frequency Min:433MHz, Frequency Max:915MHz, Modulation Type:FS 制造商:Semtech Corporation 功能描述:290MHz- 1GHz RF Transceiver
SX1231ITSTRT 制造商:Semtech Corporation 功能描述:LOW-POWER INTG UHF TRANSCEIVER
SX1231J 制造商:SEMTECH 制造商全称:Semtech Corporation 功能描述:Low Power Integrated UHF Transceiver with On-Chip 20dBm PA
SX1231JIMLTRT 制造商:Semtech Corporation 功能描述:UHF TRANSCEIVER FOR ARIB
SX1231SKB433 制造商:Semtech Corporation 功能描述:
SX1231SKB915 制造商:Semtech Corporation 功能描述:USB KIT - SX1231 915MHZ 制造商:Semtech Corporation 功能描述:development kit